Name: Randall Aiken
E-Mail: reaiken@aikenamps.com
Date: 12/12/99 9:18 AM
Subject: Re: Tapped Pot Source


That was me, but I didn't save the post. I simply used the impedance scaling
formulas available in the paper on my website entitled "Tone control scaling". I
scaled all impedances by the 250k/350k impedance scaling factor (ZSF = 0.714). 
The new values are obtained by the following formulas:

R' = R*ZSF 
L' = L*ZSF 
C' = C/ZSF

If nobody archived that post, I'll recalculate the values if needed, but it should
be fairly straightforward with the above formulas.

Randall Aiken 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Name: Rob W.
E-Mail: wiserobe@msu.edu
Date: 12/12/99 6:39 PM
Subject: Re: Tapped Pot Source


Hello!!

I was the one who asked Randall that question a month or two ago and here is
what he figured out...

C1=350pF (not 250)
C2=.14uF (not .1uF)
C2=.07uF (not .5uF)
C4=.007uF (not .005uF)
Slope Resistor= 71.4K (not 100K)
Bass Pot= 200K (not 250K)
Mid Resistor= 4.9K (not 6.8K)

Good Luck!!
And if there are anymore questions about that post, I have a hard copy version
that I can retype..

Cheers!
Rob W. 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Name: Randall Aiken
E-Mail: reaiken@aikenamps.com
Date: 12/12/99 9:23 PM
Subject: Re: Tapped Pot Source


Those were the calculated values, I had recommended standard values as well.
I think they were:

C1=350pF (100pF in parallel with 250pF)
C2=0.15uF
C2=0.068uF
C4=0.0068uF (6800pF)
Slope Resistor= 68k
Bass Pot= 200K
Mid Resistor= 4.7K

Randall Aiken